I will give infuse a go and see how it is

Discord is the best place for help for actual budget, it is very active

Memmy is now in the App Store but you’re probably better off signing up through test flight so you can get the almost daily updates.

No offense taken, this is all new to me so I’m just trying to understand. If this is how the hardlinking works then I’m all set, thanks!

I am able to get jellyfin/plex to work with the correct folders so they see my media when after it’s been copied over by radarr.

I am certain radarr is copying and not hardlinking. Going to the properties of the torrents folder and the properties of my media folder is showing that each folder is using up the same amount of space. Unless this is how it’s shown when hardlinking is being used? I don’t know how to check my disk space in anything but terabytes so it’s hard to say how much space is being used that way when a file I download is only 1GB.

So for all docker apps use just /data and for jellyfin you can use /data/media -I am using /data for all my docker apps

In Radarr: add root folder /data/media/movies add download client with radarr category -how do I change the root folder within radarr? I do have a radarr category setup for qbittorrent

In qbittorrent: Eddit your radarr category and set download path as /data/torrent/movies -I have set this up but qbittorrent still saves them in my /data/torrent folder

In jellyfin: Add movie library with path /data/media/movies -I can get jellyfin/plex to work ok

So when you add a movie in radarr, it will start downloading it in '/data/torrent/moviesand once its finished it will be renamed and hard linked todata/media/movies` -qbittorrent is not downloading to /data/torrent/movies even though I set the category to. Radarr is then copying my files to my media folder instead of hardlinking.

Hard linking is by default, but you can check in Settings - Media Management - Importing (make sure to enable “advanced” in radarr) -I do have the setting turned on to hardlink but it’s copying

I half follow. I have given radarr access to the top level folder (/data, not /data/media) so it should see everything. qbittorrent is linked to /data/torrents for my downloads. Where in radarr might I map the folders so it’s hard linking instead of copying?

Yup, HomeKit can 100% work without internet. It’s a requirement of being HomeKit certified. I block internet access to all my HomeKit devices and they work just fine.